Could you tell me more about Fuzzy logic control, kindly share the web resources with me. Thanks.
mail from MA
some fuzzy logic control Resources in the web
Guide on how to build my own RFID transmitter and receiver?
Question - i want a continuity tester circuit or get one.
mail by RB
Here are some pages that might help
I was reading about some IC's from Maxim/ Dallas saying " Simple battery characterizer" for plotting a charging/ discharging cycles & graphs are available on computer for study I want to plot an extensive data of these batteries.
From MO
Dear Solderman, i hope you know how to dessolder a wave soldered component from a board. There is problem because the pins are two face soldered. - thanks
mail from JS
Sending a few sites, read them all and then tell me.
Desoldering - Wiki
A component with one or two connections to the PCB can usually be removed by heating one joint, pulling out an end of the component while the solder is molten (bending the other lead to do so), and repeating for the second joint. Solder filling the hole can be removed with a pump or with a pointed object made of a material which solder does not wet, such as stainless steel or wood.
How to Desolder
One of the most frustrating parts of building electronic circuits is getting something wrong. For a board that should take ten minutes to put together, you could spend an hour just trying to fix a component that you got backwards. Sadly, desoldering it’s not as easy as soldering in reverse.
Desoldering requires two main things: a soldering iron and a device to remove solder. Soldering irons are the heat source used to melt solder. Irons of the 15W to 30W range are good for most electronics/printed circuit board work.
Desoldering THM and SMT
Desoldering is a topic that no one seems to get to excited about until the time comes when people discover that a lot of damage is being done during this operation.
delabs
mail from JS
Sending a few sites, read them all and then tell me.
Desoldering - Wiki
A component with one or two connections to the PCB can usually be removed by heating one joint, pulling out an end of the component while the solder is molten (bending the other lead to do so), and repeating for the second joint. Solder filling the hole can be removed with a pump or with a pointed object made of a material which solder does not wet, such as stainless steel or wood.
How to Desolder
One of the most frustrating parts of building electronic circuits is getting something wrong. For a board that should take ten minutes to put together, you could spend an hour just trying to fix a component that you got backwards. Sadly, desoldering it’s not as easy as soldering in reverse.
Desoldering requires two main things: a soldering iron and a device to remove solder. Soldering irons are the heat source used to melt solder. Irons of the 15W to 30W range are good for most electronics/printed circuit board work.
Desoldering THM and SMT
Desoldering is a topic that no one seems to get to excited about until the time comes when people discover that a lot of damage is being done during this operation.
delabs